Not much done today
Waiting for the steel plate so i can see if it seals properly before I put the heads on. Going to route a groove around the edge of the plate so some sealant will stay in there giving a better seal. Just in case.
Test fitted the adaptors into the oil inlet/outlets - no probs, but noticed a ridge inside the adaptors that might weaken the oil pressure. Drilled it out to be smooth all the way through.
Thats about it. Covered it with a plastic bag 'till I get the plate tomorrow. Says the weather is going to be peeing down until friday, so i'll be working on the 3 litre, not taking the 2.5 apart.
Test fitted the adaptors into the oil inlet/outlets - no probs, but noticed a ridge inside the adaptors that might weaken the oil pressure. Drilled it out to be smooth all the way through.
Thats about it. Covered it with a plastic bag 'till I get the plate tomorrow. Says the weather is going to be peeing down until friday, so i'll be working on the 3 litre, not taking the 2.5 apart.
posted by Reverb at 7:58 pm
0 Comments:
Post a Comment
<< Home